(no subject)

[abigailbrady]

back in london.

my boiler appears to have broken or something over christmas. it's a combination boiler. fails with error A01 which apparently means "failed to ignite". however, it does produce hot water for a couple of minutes after I reset it before then failing again. so either it has an immersion heater or somesuch as well or it did ignite after all?

Comments

[timeplease.livejournal.com]

Last time I had combi boiler problems (with similar symptoms) it was just the water pressure in the heating circuit being too low. The pressure gauge should read about 1.5 bar.